System settings
83
Other Settings
These are the settings for the brightness of the indicators on the BRIDGE CAST X as well as for what the level meters display.
1.
On the menu screen, click the “SYSTEM” tab and set the parameters in the respective menus.
Adjusts the brightness of all indicators.
* Even with the minimum setting of “0”, the indicators do not go completely
dark.
Sets what is shown by the CH 1–4 level meters.
The volume is always shown.
The level meters operate as a level meter that shows the input levels for each
channel.
The volume is shown instead when you operate the CH [1]–[4] knobs on this unit.
When mute is on, this sets how the color indicators light up.
The color indicators blink.
The color indicators go dark.
Boost 1
Boost 2
When this is set to “Boost 1” or “Boost 2”, this amplifies the headphone volume.
Specifies whether HDCP is enabled (ON) or disabled (OFF).
Copy-protected (HDCP) video can be input. HDCP is also added to the video that is
output.
* Video is not output from the USB II port.
* Audio is not output from the USB I and II ports.
Video is output without adding copy protection (HDCP). Note that you cannot
input copy-protected video to this unit.
FORMAT
Sets the formats that can be selected from the output destination’s livestreaming app.
YUY2 and Motion JPEG can be selected.
Only YUY2 can be selected.
To Next Page
Loading...
Need help?
General
