Roland FANTOM-8 - Operations in the Display; SCENE SELECT Screen; TONE EDIT Screen; ZONE VIEW Screen

13
Basic Operation
Operations in the Display
This unit’s display is a touch panel; you can perform various
operations by directly touching the display. There are many
screens, but here we explain the typical screen operations.
5 A light touch with your finger is sufficient to operate the touch panel.
The touch panel might be damaged if you press it strongly, or if you
press it with a hard object. Do not use excessive force, and use only your
finger to operate it.
5 Text enclosed in square brackets [ ] indicates a button or knob on the
panel. Text enclosed in angle brackets < > indicates a button, knob, or
icon in the display that you can “touch.” Icons such as “OK” or “CANCEL”
that are shown in the lower part of the display and respond to the
[E1]–[E6] knobs as well as to touch in the display are expressed in this
document using a form such as “Select [E6] OK.”
MEMO
If you lose track of which screen you’re in, you can return to the SCENE SELECT
screen by pressing the [EXIT] button several times or by pressing the [SCENE
SELECT] button.
By touching the <
> icon in the upper left of the screen, you can return to
the previous screen.
SCENE SELECT Screen
Opens a menu. Touch to move between screens.
Switches to the next
(previous) page.
Touch to select a
scene.
This shows information about the parameters that you can control using knobs [E1]–[E6].
TONE EDIT Screen
Switches to the PRO
EDIT screen.
Touch to switch
between tabs. Swipe
to scroll.
Touch to move the cursor. Drag to
edit a value.
Touch to move
between screens.
Touch to turn a switch
on/off or to select.
Touch to select a
parameter.
This shows information about the parameters that you can control using knobs [E1]–[E6].
Touch to close a
window.
Drag to edit a value.
ZONE VIEW Screen
Touch to open
the list.
Touch to turn a switch
on/off.
Touch to move the
cursor.
MENU Screen
Returns to the screen of the next-higher level.
Touch to move
between screens.
RENAME Screen
Touch to enter characters.
Symbols
Cancel.
Change the
input position
Confirm.
REC STANDBY Screen
From the menu, use the [E4] knob to select a parameter, and confirm.
Touch to open the list.