120
System mode
Settings related to MIDI transmission (Tx MIDI)
Parameter
Range Description
Tx Prog Change
(Transmit Program Change Switch)
OFF,
ON
Specifies whether or not program changes will be transmitted from MIDI
OUT when the patch of each part is changed.
Tx Bank Select
(Transmit Bank Select Switch)
OFF,
ON
Specifies whether or not bank select messages will be transmitted from MIDI
OUT when the patch of each part is changed.
Tx Active Sens
(Transmit Active Sensing Switch)
OFF,
ON
Specifies whether Active Sensing messages will be transmitted (ON) or not
(OFF).
Tx Patch Edit
(Transmit Patch Edit Type)
QUICK,
CC
Specifies the type of MIDI message that will be used to communicate with ex-
ternal devices when the faders are moved.
QUICK:
Fader data will be transmitted and received as control changes and
as system exclusive data.
CC:
Fader data will be transmitted and received as control changes. The
amount of data will be smaller than for TYPE-QUICK.
Tx Edit Data
(Transmit Edit Data Switch)
OFF,
ON
Specifies whether fader operations will be transmitted as system exclusive
messages (ON) or not (OFF).
Soft Through OFF,
ON
Specifies whether or not MIDI messages received at the MIDI IN will be re-
transmitted without change from the MIDI OUT.
Settings related to MIDI reception (Rx MIDI)
Parameter Range Description
Remote Kbd Switch
(Remote Keyboard Switch)
OFF,
ON
Set this parameter “ON” when you want to use an external MIDI keyboard
instead of the MC-808’s keyboard pads.
* Set it to “OFF” to control the MC-808 from an external sequencer, as a
multi-timbre sound generator with sixteen parts. Patches can be played
back by part, according to the channel used for sending MIDI data from the
external sequencer.
Device ID 17–32 Specifies the Device ID number of a system exclusive message on the MC-808.
* A system exclusive message can only be received if the device number in-
cluded in the message matches the device ID number set up on the receiv-
ing MIDI equipment. Using this function enables different system exclusive
messages to be received by more than one MC-808 unit at the same time.
* At the factory settings, the device ID number is set to “17.”
Rx Prog Change
(Receive Program Change Switch)
OFF,
ON
Specifies whether or not each part will receive program changes.
Rx Bank Select
(Receive Bank Select Switch)
OFF,
ON
Specifies whether or not each part will receive bank select messages.
Rx Exclusive
(Receive Exclusive Switch)
OFF,
ON
Specifies whether or not each part will receive system exclusive messages.
MC-808_r_e.book 120 ページ ２００７年７月１７日 火曜日 午後５時１分
To Next Page
Loading...
