126
System mode
You can reset the MC-808’s settings to the factory-set state.
For details, refer to
“Restoring the factory settings (Factory
Reset)”
(p. 25).
The MC-808’s internal patches are all user patches that can be
overwritten. For this reason, there’s a “protect” setting that you can
apply to each patch bank so that you won’t inadvertently write over
data that you actually wanted to keep.
We recommend that you decide on a bank that you’ll use to store
your own original creations, and leave the protect setting enabled for
the other banks.
1.
Press [SYSTEM] to enter System mode.
2.
Hold down [SHIFT] and press keyboard pad [16].
The SYSTEM:UTILITY screen will appear.
3.
Use [CURSOR ] to select “Patch Protect.”
fig.08-011
4.
Press [ENTER].
5.
Use [CURSOR ] to select the parameter, and use the
VALUE dial or [INC] [DEC] to turn the protect setting on/off.
6.
Unless you save system settings, they will revert to their
prior state when you turn off the power.
Press [WRITE] if you want to save the settings.
* If you do not wish to save changes, press [EXIT] to return to the
previous screen.
With the factory settings, Patch UserA–G and Rhythm User A
are protected. If you want to save data in a protected bank,
you’ll need to turn off the protect setting first.
Performing a factory reset
(UTILITY)
Protecting individual patch
banks (UTILITY)
Parameter Range
Patch User A001-128 – H001-128 ON, OFF
Rhythm User A001-128 – B001-128 ON, OFF
MC-808_r_e.book 126 ページ ２００７年７月１７日 火曜日 午後５時１分
To Next Page
Loading...
