Roland MC-808 - Realtime Transpose During Playback

47
Playing patterns
Pattern mode
fig.03-012
1. Hold down [TRANSPOSE] and turn the VALUE dial or use
[INC] [DEC] to specify the desired transposition.
While you hold down the button, the display will show the
current value.
fig.03-013
Range: -12–+12 semitones (factory setting is 0)
2. When you release the button, the transposition will be
applied.
To return to the original pitch, press the [TRANSPOSE] button
once again to turn off the indicator.
* The rhythm part is not transposed.
The same applies when using a sample as a rhythm set.
1. Make sure that both the [PATTERN CALL] and [RPS]
indicators are dark.
2. Hold down [TRANSPOSE] and press a keyboard pad to
specify the desired transposition.
You can specify a transposition in the range of -12–+12
semitones, centered on the C4 note (keyboard pad [2] when the
Octave Shift setting is “0”).
fig.03-014
If you want to specify a negative value, press [OCT -] so it’s lit.
fig.03-014
3. When you release the keyboard pad, the transposition will
be applied.
To return to the original pitch, press the [TRANSPOSE] button
once again to turn off the indicator.
“Shifting the pitch in octave units (Octave Shift)” (p. 48)
* The Realtime Transpose setting will always be “0” immediately after
you turn on the power.
* The rhythm part is not transposed.
The same applies when using a sample as a rhythm set.
Transposing during playback (Realtime Transpose)
Using the VALUE dial or [INC] [DEC]
1
1
Using the keyboard pads
C4
C4
MC-808_r_e.book 47 ページ ２００７年７月１７日 火曜日 午後５時１分