96
Editing samples (Sample Edit)
On the MC-808, waveforms (samples) that you’ve sampled, loaded, or imported can be easily selected and edited in the same way as
patches or rhythm sets.
The sample settings you edit will be lost when you turn off the power. If you want to keep your edits, you must save them (p. 101).
Waveforms (samples) that you’ve sampled, loaded, or imported can
be selected and edited as “sample patches” in the same way as
conventional patches or rhythm sets.
Selecting a patch used in a pattern
1.
In Pattern mode, select a pattern.
2.
Select the part that uses the sample patch you want to edit.
The currently selected sample patch is displayed.
fig.04-026.e
3.
Press [PATCH/SAMPLE] to enter Patch/Sample mode.
fig.04-025.e
4.
Use [CURSOR ] to move the cursor to the sample
patch number, and use the VALUE dial or [INC] [DEC] to
select the desired sample patch.
Selecting a patch in Patch/Sample mode
1.
Press [PATCH/SAMPLE] to enter Patch/Sample mode.
The currently selected patch/rhythm set (
the current patch/
current rhythm set
) is shown.
fig.04-025.e
2.
Use [CURSOR ] to move the cursor to the sample
patch number, and turn the VALUE dial or use [INC] [DEC]
to select the desired patch group.
USAM
: User samples
CSAM
: Card samples
* You can also use the GROUP [USER]/[CARD] buttons to make your
choice.
The current/next displays will show something like the
following.
Example: For USER SAMPLE 0001
fig.04-027
3.
Use the VALUE dial or [INC] [DEC] to select the desired
patch.
Selecting a sample patch
Types of sample patch
USAM: 0001–2000
These are samples in user memory.
A maximum of 2,000 samples can be saved.
CSAM: 0001–7000
These are samples in a CompactFlash card.
A maximum of 7,000 samples can be saved.
Selecting a sample patch
Sample patch name
Part number
Name of the pattern
Sample patch name
Part number
Sample patch number
Sample patch name
Part number
Sample patch number
MC-808_r_e.book 96 ページ ２００７年７月１７日 火曜日 午後５時１分
To Next Page
Loading...
