Roland MC-808 - Microscope Utilities; Specifying the Types of Events to View (View Switch); Moving an Event (Move Event)

82
Editing patterns (Pattern Edit)
In addition to the Create/Erase Event operations, you can use microscope utility operations to do the following things.
You can select the types of events that will be shown in the display.
This is convenient when you want to edit only a specific type of
event, since you’ll be able to find and edit those events more easily if
you see only that type of event.
1. In the Microscope screen, hold down [SHIFT] and press
[REC].
The MICROSCOPE UTILITY screen will appear.
fig.03-113
2. Use [CURSOR ] to select “View Switch” and press
[ENTER].
fig.03-114
3. Use [CURSOR ] to select the event, and use VALUE
dial or [INC] [DEC] to turn “ON” the display of events that
you wish to view.
4. Press [EXIT] to return to the Microscope screen.
Only the types of events you turned ON in step 3 will be shown.
1. In the Microscope screen, display the event that you want
to move.
2. Hold down [SHIFT] and press [REC].
The MICROSCOPE UTILITY screen will appear.
3. Use [CURSOR ] to select “Move Event” and press
[ENTER].
fig.03-115
4. Input the location (measure–beat–tick) to which you want to
move the event.
fig.03-116
Use [CURSOR ] to select measure–beat–tick, and use
VALUE dial or [INC] [DEC] to input the value.
5. Press [ENTER] to execute.
Microscope Utilities
Specifying the types of events to
view (View Switch)
EVENT
VALUE
Note
OFF, ON
Program Change OFF, ON
Control Change OFF, ON
Pitch Bend OFF, ON
Poly Aftertouch (Polyphonic Aftertouch) OFF, ON
Ch Aftertouch (Channel Aftertouch) OFF, ON
SysEx (System Exclusive) OFF, ON
Tempo Change OFF, ON
Mute Control OFF, ON
Moving an event (Move Event)
MC-808_r_e.book 82 ページ ２００７年７月１７日 火曜日 午後５時１分