51
Playing patterns
Pattern mode
RPS Hold
You can make a phrase continue playing even after you release your
finger from the keyboard pad.
To hold all phrases
1.
Press [HOLD] so the indicator is lit.
2.
Press a keyboard pad to play a phrase.
You can stop that phrase by pressing the same pad once again.
To hold individual phrases
1.
Hold down [HOLD] and press a keyboard pad to play a
phrase.
[HOLD] will blink, and that phrase will continue playing until
you press the same pad once again.
2.
To play a phrase that you want to hold, hold down [HOLD]
and press the appropriate pad, as described in step
1
.
The phrases will play together.
3.
To play a phrase that you do not want to hold, press only
the appropriate pad.
When you release your finger from the pad, that phrase will
stop playing.
* In steps 1 and 2, you can also press [HOLD] while pressing the
keyboard pad to play the phrase, as an alternative to holding down
[HOLD] and then pressing the pad.
To stop all phrases, press [HOLD] so the indicator goes out.
RPS Settings
1.
Hold down [SHIFT] and press [RPS].
The RPS setup screen will appear.
fig.03-023
2.
Use [CURSOR ] to select a parameter, and turn the
VALUE dial or use [INC] [DEC] to set the value.
Parameter Range Description
RPS
(RPS Set)
01–50 RPS set to edit
RPS Part
(RPS Part)
Part 1–16 RPS part to edit
Pat Bank
(RPS Part Patch
Bank)
Patch assigned to RPS part
Pat
(RPS Part Patch
Number)
Part Output Sel
(RPS Part Out-
put Select)
DRY,
MFX1,
MFX2,
COMP,
DIR,
RHY
How the original sound
of each RPS part will be
output
DRY:
Output to MIX OUT-
PUT jacks without pass-
ing through effects
MFX1 (2):
Output through multi-
effects 1 (or 2)
COMP:
Output through the
compressor
DIR:
Output to DIRECT
OUTPUT jacks without
passing through effects
RHY:
Output according to the
settings of the rhythm
set assigned to the part
RPS Mixer — Refer to p. 52.
RPS Trigger Quantize
When using RPS during pattern playback, patterns and phrases
may not play back in precise alignment, depending on the
timing at which you press the keyboard pads. On the MC-808
you can specify the playback timing of the phrase, so it will play
back in precise synchronization with the pattern (“RPS Trig
Qtz” (p. 119)).
MC-808_r_e.book 51 ページ ２００７年７月１７日 火曜日 午後５時１分
To Next Page
Loading...
Need help?
General
