Roland Soljet EJ-640 - Outputting

Setup of Media
2
Basic Operation
36
6. Set the drying method and time after printing.

Press or to select a value.
Press
to conrm your entry.
For the individual setting method and the description of this setting item, refer to the following section.

P. 88, "Drying the Trailing Edge of the Printing Area on the Dryer"

Press or to set the drying time.
Press
to conrm your entry.
For the individual setting method and the description of this setting item, refer to the following section.

P. 89, "Setting the Drying Time after Printing"
7. Save the settings as a preset.

Press to select [SAVE].
Press
to conrm your entry.
Even if you select [NEXT], the performed settings are retained. How-
ever, the next time you operate the [MEDIA SETTING] menu, your
settings will be overwritten.

Press or to select a destination to save
the preset.
You can select a name from NAME1 to NAME8.
Press to conrm your entry.
FEED FOR DRY
DISABLE ENABLE
Drying method after printing
Set whether the media should be fed until the trailing edge of the printed area is put on the dryer
after the 1st page is printed. To make sure to dry the entire printed area, select [ENABLE]. If [DISABLE]
is selected, the trailing edge of the printing area is not fed to the dryer unless you continue with a
subsequent printing operation.
DRYING TIME
10min 10min
Example of setting time (general guide)
Note: The setting time varies according to the settings such as
the type of media and the printing quality.
Condition: Non-coated vinyl chloride media
Setting time: About three minutes
Drying time after printing
Set the drying time after the 1st page is printed. The next operation is not started until the set time
passes.
PRESET
[SAVE] NEXT
SAVE TO
NAME1
Current
setting
Setting after
change
Current
setting
Setting after
change