Roland SP-404MK2 - Page 62

Combining Samples to Create a Pattern (PATTERN SEQUENCER)
62
Controller
Explanation
[DEL] button + [A/F]
button
Deletes the notes (for one measure) corresponding to the selected pad.
[DEL] button + [B/G]
button
Deletes the notes (for one measure) corresponding to all pads.
[HOLD] button
Plays back only the selected pad.
[ROLL] button + [CTRL 1]
knob
You can record the motion of [CTRL 1] knob in the steps.
* This is enabled when MODE is “TRIG”.
[ROLL] button + [CTRL 2]
knob
You can record the motion of [CTRL 2] knob in the steps.
* This is enabled when MODE is “TRIG”.
[ROLL] button + [CTRL 3]
knob
You can record the motion of [CTRL 3] knob in the steps.
* This is enabled when MODE is “TRIG”.
[SHIFT] button + [REC]
button
You can switch to TR-REC by pressing the [REC] button while holding down the [SHIFT] button
during pattern playback.
●
If you press the [RECORD SETTING] button while the pattern is recording, the RECORD SETTING screen is shown. Note that
you can’t set the LENGTH or TIME SIGN parameters at this time.
● Press the [EXIT] button to return to the previous screen.