Roland SPD-SX - Dividing a Wave (CHOP)

Sampling
36
Dividing a Wave (CHOP)
Here’s how to create new waves by chopping (dividing) an existing wave.
Preparations for sampling
1. Press the [SAMPLING] button to access the SAMPLING screen.
2. Use the cursor [ ] [ ] buttons to select “CHOP,” and press the [ENTER] button.
The sampling setup screen will appear.
3. Use the cursor buttons and the [-] [+] buttons to make settings for sampling.
Parameter Value Explanation
SOURCE KIT001–100, PAD1–9 Select the original wave that you want to chop.
KIT001–100
Select the kit to which the chopped waves are to be assigned.
* You can only select an empty kit in which no wave has been assigned to any of the pads.
Start sampling
Example: Chopped to pad 7 and pad 9
4. Start sampling to
pad 7
5. Start sampling to
pad 9
6. Stop sampling
Pad 7
Pad 7
Pad 9
Chopped to pad 7
and pad 9