Roland SPD-SX - Playing the Second Wave (SUB); Applying a Kit Effect (KIT FX)

Customizing a Kit
46
Playing the Second Wave (SUB)
Here you can make settings for the second wave (sub wave).
Make these setting when you want two waves to sound simultaneously from a single pad.
Parameter Value Explanation
SUB 00001–10000
Selects the wave that will be sounded by the pad.
MEMO
• The SPD-SX contains preload waves.
• The preload waves are also stored on the supplied CD-ROM. If you want to make use of
the preload waves that came with the unit when it left the factory, load waves from a USB
ash drive or your personal computer (p. 39).
• By holding down the [PAD CHECK] button and using the [-] [+] buttons you can select the
wave in steps of 10.
VOLUME 0–100 Adjusts the volume of the sub wave.
PAN L15–CENTER–R15 Adjusts the stereo position (left/right balance) of the sound.
The sub-wave will sound according to the following settings.
Parameter Value Parameter Value
MUTE GROUP Same setting as MAIN (p. 45) TRIG TYPE OFF
TEMPO SYNC OFF DYNAMICS Same setting as MAIN (p. 45)
LOOP OFF POLY/MONO MONO
Applying a Kit Eect (KIT FX)
The kit eects provide a choice of 20 dierent eect types.
Two kit eects (FX1 and FX2) can be applied to each kit.
1. Choose MENU KIT FX.
2. Turn the kit eect on.
Turn FX1 SW “ON” if you want to turn FX1 on, and turn FX2 SW “ON” if you want to turn FX2 on.
MEMO
You can also turn the kit eects on/o from the top screen (p. 23).
3. Edit the parameters.
When you switch the eect type (FX1 TYPE or FX2 TYPE), the editable parameters for each eect type will be shown.
For details on the eect types and their parameters, refer to the Eect Guide.
For the procedure, refer to “Basic Editing Procedure” (p. 16).
MEMO
The Eects Guide can be downloaded from the Roland website.
Visit the following URL, choose “owner’s manuals,” and search for the model name “SPD-SX.”
http://www.roland.com/support/en/