Overall Settings for the SPD-SX
Overall Settings for the SPD-SX
65
Importing an Audio File from a USB Flash Drive (WAVE IMPORT)
An audio le from a USB ash drive can be imported into the SPD-SX as a wave.
Refer to “Importing Audio Files from a USB Flash Drive (WAVE IMPORT)” (p. 39).
Loading Data from a USB Flash Drive (LOAD (USB MEMORY))
Here you can load data that you previously saved to a USB ash drive.
* When you execute the LOAD (USB MEMORY) operation, the data in the SPD-SX will be overwritten. If the SPD-SX contains
important data that you want to keep, save it to a USB ash drive before you proceed (p. 66).
1. Connect your USB ash drive to the USB MEMORY connector (p. 18).
2. Choose MENU UTILITY LOAD (USB MEM).
The LOAD (USB MEMORY) screen will appear.
3. Use the cursor [ ] [ ] buttons to select the command that you want to execute, and then press the [ENTER]
button.
Item Explanation
KIT+SETTINGS Kits and SPD-SX settings will be loaded.
ALL All data (waves, kits, and SPD-SX settings) will be loaded.
4. Use the cursor [ ] [ ] buttons to select the data that you want to load, and then press the [ENTER] button.
A conrmation message will appear.
If you decide to cancel without executing, press the [EXIT] button.
5. Press the [ENTER] button.
The data will be loaded.
Restoring All the Factory Default Settings
If you want to return the SPD-SX to its factory-set state, save the factory settings le to your USB ash drive, and then
execute “ALL.”
The factory settings le can be obtained from the Roland website.
Visit the following URL, search for the model name “SPD-SX.”
http://www.roland.com/support/en/
To Next Page
Loading...
