19
 
Setting Up the Kit
 
Overview
 
941
 
* Once the connections have been completed (p. 17, p. 18), turn 
on power to your various devices in the order specified. By 
turning on devices in the wrong order, you risk causing 
malfunction and/or damage to speakers and other devices.
 
fig.VolMin
 
1.
 
Turn the [MASTER] and [PHONES] completely 
to the left to lower the volume to “0.”
 
2.
 
Turn down the volume control on the 
connected amp or audio system.
 
3.
 
Push the [POWER] switch on the TD-12’s rear 
panel to turn on the power.
 
fig.PowerOn.e
 
942
 
* This unit is equipped with a protection circuit. A brief interval 
(a few seconds) after power up is required before the unit will 
operate normally.
 
4.
 
Turn on the power to the connected amp or 
audio system.
 
5.
 
While hitting a pad, gradually turn [MASTER] 
(or [PHONES]) to the right to adjust the volume 
level.
 
Turning Off the Power
 
1.
 
Completely turn down the volume of the TD-12 
and any connected external devices.
 
2.
 
Turn off the power to all external devices.
 
3.
 
Push the [POWER] switch on the TD-12’s rear 
panel to turn off the power.
 
945
 
* If you need to turn off the power completely, first turn off the 
POWER switch, then unplug the power cord from the power 
outlet. Refer to 
 
Power Supply
 
 (p. 5).
 
Turning On/Off the Power
Lower Position
ON
Precautions When Turning on the 
Power
After the power is turned on, do NOT hit any pads or 
step on the pedals until the drum kit name (following 
figure) appears in the display. Doing so can cause 
triggering problems.
fig.00-006
No Sound When Hitting the Pads or Using the 
Pedals?
Check the following points.
When Using an Amp or Audio System
• Is the amp or audio system connected to the TD-12’s 
MASTER OUT jacks?
• Is the input of the amp or audio system properly 
connected?
• Is there a problem with any connection cables?
• Is the volume turned down in the [GROUP 
FADERS] sliders?
• Is [MASTER] turned completely to the left?
• Have the input select settings of your audio system 
or amp been made correctly?
• Is the amp or audio system volume setting correct?
When Using Headphones
• Are the headphones connected to the PHONES jack?
• Is [PHONES] turned completely to the left?
TD-12_e.book 19 ページ 2007年8月8日 水曜日 午後1時20分