Roland TD-12 - 3-Way Triggering and Trigger Bank Naming

52
Chapter 5. Trigger Settings [TRIGGER]
When using the CY-15R or CY-12R/C for the RIDE, you can
three way triggering (bow, bell, and edge shot) performance
are possible.
3Way Trigger: OFF, ON
Connect as shown below, set 3Way Trigger to “ON.”
fig.05-Ride.e
Correspondences Between Playing
Method and Trigger Input
* Head-side tone for the TRIGGER INPUT 10 EDGE cannot be
sounded.
* When 3Way Trigger is set to “ON,” “RD CTRL” is displayed
for the trigger type for TRIGGER INPUT 10 EDGE. It cannot
be changed.
Each trigger bank can be named (up to 12 characters).
fig.05-BankName_70
1. In the “TRIGGER BANK” screen, select the
trigger bank you want to name.
2. [F5 (ADVANCE)] - [F5 (NAME)].
The “TRIGGER BANK NAME” screen appears.
3. [CURSOR (left/right)] to move the cursor to the
character to be changed.
4. Use [VALUE], [+/-], or [CURSOR (up/down)] to
change the character.
Function Buttons
[F1 (INSERT)]
A blank space is inserted at the cursor position.
[F2 (DELETE)]
Character at the cursor position is deleted.
[F3 (SPACE)]
Character at the cursor position is replaced by a blank
space.
[F4 (CHAR)]
Character at the cursor position changes between
uppercase/lowercase alphabet, or numbers and symbols.
5. When finished, Press [EXIT].
Playing Bow, Bell, and Edge
(3-Way Triggering)
Playing Method TD-12 TRIGGER INPUT
Bow Shot 9 RIDE head
Bell Shot 9 RIDE rim
Edge Shot 10 EDGE rim
CY-15R or CY-12R/C
Ride
EDGE
RIDE
BOW/BELL
BOW/EDGE
TD-12 Rear Panel
Naming a Trigger Bank [F5 (Name)]
TD-12_e.book 52 ページ ２００７年８月８日 水曜日 午後１時２０分