Roland TrueVIS VG2-640 - Adjusting the Ink-drying Method

Use Middle Pinch Rollers When Pulling Back or Feeding Media
Set the seng that causes the middle pinch rollers to go up automacally during pullback prinng or prinng and
cung to "DISABLE." Holding down media that is not straight or comes loose is eecve in prevenng misalign-
ment during prinng and cung.
"AUTO MIDDLE PINCH" is a funcon that causes the middle pinch rollers to automacally rise when media is
pulled back, performs overprinng and cung while they are raised. However, if you are performing lengthy print-
ing or using non-resilient media, the media will be skewed or will come loose, which may have an eect on the
output quality.
If you set "AUTO MIDDLE PINCH" to "DISABLE", the middle pinch rollers will press down on the media while mov-
ing, thus prevenng skewing or coming loose. However, because the middle pinch rollers are pressed against the
printed surface, it is easier for the rollers to leave a trace on the printed surface. Before pulling back the media,
make sure to dry it thoroughly.
P. 152「Adjusng the Ink-drying Method」
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
MENU
SUB MENU
3. Press [▶] once, and then press [▼] several mes to display the screen shown below.
SUB MENU
AUTO M.PINCH
4. Press [▶].
5. Press [▲] or [▼] to select "DISABLE".
AUTO M.PINCH
ENABLE DISABLE
6. Press [ENTER] to conrm your entry.
7. Press [MENU] to go back to the original screen.
MEMO
• Default seng: "ENABLE"
Preventing Misaligned Media
1. Optimizing the Output Quality 151