Roland TrueVIS VG2-640 - Printing and Cutting Are Misaligned

Is the media wrinkled or warped?
Wrinkled or warped media may cause crop mark detecon to fail. Avoid using wrinkled or warped media.
If the crop marks cannot be detected automacally, you can perform alignment manually.
RELATED LINKS
・ P. 174 "Aligning the Posions of Cung with Crop Marks Manually"
・ P. 187 "Adjusng the Level of the Sensor for Reading Crop Marks According to the Media"
Is the media size too large?
Large media may lead to large errors, which may cause crop mark detecon to fail.
When you want to use lengthy media, we recommend performing output with the data separated into sizes that
are as short as possible.
If the crop marks cannot be detected automacally, you can perform alignment manually.
RELATED LINKS
・ P. 174 "Aligning the Posions of Cung with Crop Marks Manually"
Are you using media that is likely to reect light?
The machine may not be able to read crop marks from media that is likely to reect light. Try [CROPSENS CALIB.]
(the correcon funcon of the sensor for reading crop marks). If the crop marks sll cannot be read, change the
media you are using.
RELATED LINKS
・ P. 184 "Correct the sensor for reading crop marks."
Are you using transparent media?
The machine cannot read crop marks from transparent media. Change the media you are using.
Automatic Detection of Crop Marks Fails
2. Problems in Cutting with Crop Marks 281