Roland TrueVIS VG2-640 - 3. Printing and Cutting Method

Step 2: Starng Output
CAUTION
Never touch the print-head carriage while output is in progress.
The print-head carriage moves at high speed. Coming into contact with the moving carriage may cause
injury.
Procedure
1. Close the front cover.
2. Check that [SETUP] is lit.
If [SETUP] is not lit, the setup is not completed. Lower the loading lever, and then press the [ENTER] key.
3. Check that the screen shown below (the top menu) is displayed.
If the top menu is not displayed, press [MENU].
W1100mm
4. Send the output data from the computer.
For informaon on how to create the output data, refer to the documentaon for the included soware RIP.
IMPORTANT
Output Is Not Possible in These Situaons
• The machine does not run when a cover (front, le, right, or ink slot) is open.
• Data from the computer is not accepted when [SETUP] is dark.
• Data from the computer is not accepted when you are not at the top menu.
Points that must be observed
• Never open a cover (front, le, or right) while output is in progress. Doing so interrupts prinng.
• During output, do not touch the media. Doing so may obstruct the media feed or cause the media to rub against the print
heads, which may result in a paper jam or damage to the heads.
• Keep the loading lever raised when the machine is not in use.
When not using the machine, remove any media and store it in a suitable environment.
• If the machine is le with the media loaded, the media may be damaged, which may adversely aect prinng. When not
using the machine, remove any media and store it in a suitable environment.
Cutting Output
88 2. Cutting Method