Correcng the Misalignment of Prinng and Cung
This is a correcon method performed when prinng followed immediately by cung yields posioning for print-
ing and cung that is slightly misaligned.
Print alignment marks, perform detecon of the printed marks, and then correct the discrepancy. Subtle misalign-
ment between the prinng and cung posions may occur due to the thickness of the media or the head height.
We recommend that you make correcons to match the media you are using.
1. Adjust the misalignment of the ink landing posion.
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
3. Press [▲] or [▶] to display the screen shown below.
4. Press [ENTER].
Prinng of the test paern starts.
5. When prinng is nished, press [▼], then [▶] to display the screen shown below.
6. View the printed test paern, and then determine the correcon value.
Select the value that gives the least misalignment between the two lines. In the case of the following gure,
select "-3." When you cannot choose between two sequenal numbers, select a value that is between them
(you can set correcon values in units of "0.5").
7. Press [▲] or [▼] to select the correcon value.
8. Press [ENTER] to conrm your entry.
9. Press [◀] or [▲] to display the screen shown below.
10. Press [ENTER].
Prinng of the test paern starts.
11. Check the test paern to see whether the correcon was successful.
Check that the misalignment is minimized for the two vercal lines indicated by " " (that is, the current
correcon value). If the misalignment is smaller for another set of vercal lines, set the correcon value
again.
12. When you have successfully performed the correcon, press [MENU] to go back to the original screen.
Accurately Adjusting the Settings for Printing and
Cutting
1. Optimizing the Output Quality 169
To Next Page
Loading...
