Roland TrueVIS VG2-640 - Setting the Print Heater Temperature

Seng the Print Heater Temperature
Seng the temperature of the print heater appropriately improves ink adhesion and inhibits smudging.
• With the default sengs, simply switching on the power does not make the dryer warm up to the set temper-
ature. The temperature rises to the set temperature when the media is loaded correctly and [SETUP] lights.
• Depending on the usage environment, the temperature of the print heater may become higher than the set
temperature, but this does not represent a problem.
• Temperature sengs are not possible when heater sengs "POWER" is "OFF".
Procedure
1. Press [FUNCTION].
2. Press [▼] several mes to display the screen shown below.
FUNCTION
HEATER CONFIG
3. Press [▶] or [▼] to display the screen shown below.
HEATER CONFIG
PRINT 40゜C
4. Press [▶] to display the screen shown below.
PRINT
40゜C 40゜C
5. Press [▲] or [▼] to select the temperature.
If the ink forms lumps or smudges, raise the temperature. Note, however, that a temperature that is too
high may degrade the media or cause it to wrinkle.
You can also set the temperature to "OFF". When set to "OFF", the print heater does not operate at all.
6. Press [ENTER] to conrm your entry.
7. Press [FUNCTION] to go back to the original screen.
MEMO
• Default seng: 40°C (104°F)
• You can also make this seng in the soware RIP. When you have made the seng in the soware RIP, the soware RIP's
seng is used.
RELATED LINKS
・ P. 160 "Switching O the Print Heater and Dryer Together"
Adjusting the Ink-drying Method
1. Optimizing the Output Quality 153