Roland TrueVIS VG2-640 - Accurately Adjusting the Settings for Cutting with Crop Marks; Aligning the Positions of Cutting with Crop Marks Manually

Aligning the Posions of Cung with Crop Marks Manually
Depending on the type of media, it may not be possible to detect crop marks automacally. When crop marks
cannot be detected automacally, perform alignment manually.
The following gure is given as an example to explain how to manually set the base point and align points.
The following gure is given as an example to explain how to manually set the base point (B) and align points (
).
The numbers for align points are determined with reference to the locaon of the base point, as shown in the
following gure. You cannot set the align points unless you specify the base point. Redoing the seng for the base
point clears any align points that have been set.
Procedure
1. Press [◀], [▶], [▲] or [▼] to move the center of the blade to the "base point ( )" posion.
2. Press [FUNCTION] to display the screen shown below.
FUNCTION
BASE POINT
3. Press [ENTER].
The [BASE POINT] is set. The character "B" is displayed on the screen.
W1100mm
B
4. Press [◀], [▶], [▲] or [▼] to move the center of the blade to the "align point 1 ( )" posion.
Accurately Adjusting the Settings for Cutting with
Crop Marks
174 1. Optimizing the Output Quality