Roland TrueVIS VG2-640 - Cutting to Make It Possible to Cut Corners Attractively (over Cut)

Cung to Make It Possible to Cut Corners Aracvely (Over Cut)
Cung the corners of the border of the cung line slightly longer makes it possible to cut the corners aracvely.
This is eecve when using laminated or thick media, or non-resilient media. It also has the eect of making sck-
ers easier to peel o.
Procedure
1. Press [MENU].
2. Press [▲] to display the screen shown below.
MENU
CUTTING MENU
3. Press [▶] once, and then press [▼] several mes to display the screen shown below.
CUTTING MENU
OVER CUT
4. Press [▶] to display the screen shown below.
OVER CUT
DISABLE DISABLE
5. Press [▲] or [▼] to select "ENABLE".
6. Press [ENTER] to conrm your entry.
7. Press [MENU] to go back to the original screen.
MEMO
• Default seng: "DISABLE"
Accurately Adjusting the Cutting Settings
1. Optimizing the Output Quality 167