Roland VersaSTUDIO BN-20A - Printing; Step 1: Loading Media

This section describes operations when printing only.
Refer to "Cutting / Printing and Cutting(P. 38)" , "Performing Printing and Cutting Separately(P. 46)" .
Step 1: Loading Media
Loading roll media
Procedure
1. Move the left media guide to the left edge.
(1) Push the loading lever ( ) backward.
(2) Move the left media guide ( ) to the left.
2. Attach the media flange ( ) to one end of the media bar ( ) .
Insert the side of the media bar with a hole (
) into the media flange.When loading roll media
with a 3-inch paper tube inner diameter, attach the media flange with ( ) on the inside. When
loading roll media with a 2-inch paper tube inner diameter, attach the media flange with (
)
on the inside.
3. Secure the media flange and media bar with the mounting pin ( ).
Printing
20 Basic Operations