Aligning Automatically and Cutting
This section describes how to make settings when using the BN-20 driver. When using VersaWorks, refer
to the [VersaWorks Help].
Procedure
1. Print with a crop mark, and then reload the media that was removed.
Points for Media Setting
Place the crop marks ( ) on the blade protector ( ).
Angled no more than 5 degrees. Otherwise alignment becomes impossible.
2.
Display the BN-20 driver's Printing Preferences screen.
P. 10 "How to Open the BN-20 Driver's Printing Preferences Screen"
3. Select [CropMark] on the [Printer Adjustment] tab.
4. Select [Cut].
Performing Printing and Cutting Separately
Optimizing the Output Quality 49
To Next Page
Loading...
