11
RootWave Pro User Guide
• To prevent risk of accidental activation when moving between
weeds with the Treatment Lance, safe stop the system by
squeezing one or both of the triggers fully inwards. To prevent
risk of accidental activation during pauses in use, turn the power
isolator switch on the Power Module to ‘Off’ and turn off the
generator.
• Do not drop or expose parts of the system to impact of any kind
as this can damage the product and its safety systems. Check all
parts of the RootWave Pro system for damage each time before
use. If any parts of RootWave Pro appear to be damaged, do not
use, contact your RootWave Pro supplier.
• The Power Module has a lip on the front and rear of the lid but
this lip is not designed to enable carrying of the Power Module
and could result in it being dropped which would damage the
product and its safety systems. The Power Module should only be
lifted from its base using a forklift and or lifting straps.
• Working alone with potentially hazardous equipment can
increase risk. If working alone ensure a suitable lone working
protocol, written by a suitably qualified Health and Safety advisor,
is in place and compliant with local regulations and procedures.
• Water can conduct electricity. Keep connector caps in place until
you are connecting cables into the Treatment Return. Replace
connector caps when not in use and while re-siting the Treatment
Return. Do not place exposed cable connectors onto wet or
damp ground during installation or re-siting of the Treatment
Return.
• The Treatment Lance length from grip centre to tip is 1.6m. Be
careful of overhead hazards such as power lines. There should be
no need to raise the Treatment Lance electrode above 30cm from
the ground.
To Next Page
Loading...