BRP-Rotax
INSTALLATION MANUAL
Figure 7.13
1
Shift contact
guidance
2
Retaining plate
Step
Procedure
5
Mount Allen screw (pos. 1), lock wash-
er (pos. 2) and spacer (pos. 3) togeth-
er with the shift contact guidance (pos.
4) to the engine housing. Tightening
torque 22 Nm.
Figure 7.14
1 Allen screw
2
Lock washer
3
Spacer
4
Shift contact guidance
Step
Procedure
6 The alignment between point -1- and
point -2- must be given. Otherwise it
can cause increased friction, which
has a negative impact on shifting
behavior.
Figure 7.15
1 Point 1
2
Point 2
Step
Procedure
7
Mount sleeve (pos. 1) onto the retain-
ing plate (pos. 2).
Figure 7.16
1 Mount sleeve
2
Retaining plate
Step
Procedure
8
Mount second Bowden cable (pos. 1)
through shift contact guidance and
sleeve onto the retaining plate (pos.
2).
No washer is necessary on this Bow-
den cable.
6
Page 8
Edition: September 01 2019
Effectivity: 125 MAX DD2 evo
To Next Page
Loading...
