Platinum Plus
21
Standard Mode Programming Steps
1.5
Control | Cool
Pad
1. Day: Growth Day
2. Start Time: Earliest time to turn on
water.
3. End Time: Time to stop water.
4. Tunnel Diff: Relative temp to
Tunnel ON temp in Temp & Timer
Settings. May be negative (push
+/- after entering differential
degrees).
5. To Humidity: Maximum humidity
at which to apply this line.
6. On Sec: Cycle timer On time
7. Off Sec: Cycle Off time.
Enter up to 20 Cool Pad
settings. You can use the same
growth day several times, and
increase water flow for higher
temperatures.
You can flush the cool pad
daily to wash out
contaminants. Check Cool Pad
Flush options under Help | Set.
1.6
Control | Light
1. Day: Growth Day
2. Start Time: Time at which lights
turn on, or sunrise starts.
3. End Time: Time at which lights
turn off, or sunset finishes.
4. For full time, set start and end
times both to 00:00.
5. Intensity: light dimmer setting.
6. To delete a line, set growth day to
0 and exit menu. Add new lines at
the end and exit menu. Reenter
table to see lines in correct
position.
You can enter several start and
stop times for the same growth
day. One set of settings carries
forward until a new growth
day is programmed.
Light spiking: if using a
dimmer, program a full time
background level using 00:00
start & end times, then spike
levels at particular stop/end
times.
1.7
Control | Feed
Feed Clock that matches the capability
of the light table. Program feed times
by growth day. Programmed times
carry forward until changed.
For full feeding, enter a growth day of
1, and leave both start and end time
settings at 00:00.
See Management, Alarm
Settings for feed alarms and
automatic shut off of feed in
the event of a feed system
malfunction.
Turn on Advanced Alarms in
Management | Alarms | Help |
Advanced Alarms.
1.8
Control | Extra
Systems
Extra systems are four stand alone
simple controllers. Each provides
these basic controls:
1. Start Time: earliest time to activate
extra system.
2. End Time: latest time extra system
1. For 24 hour operation,
leave start and end times at
00:00.
2. For operation, all extra
system settings must be
True. For example, From
Temp must be below To
To Next Page
