Platinum Plus
37
Precision Mode Programming Steps
1.4
Control | Cool
Pad
1. Day: Growth Day
2. Start Time: Earliest time to turn on
water.
3. End Time: Time to stop water.
4. Tunnel Diff: Relative temp to
Tunnel ON temp in Temp & Timer
Settings. May be negative (push
+/- after entering degrees).
5. To Humidity: Maximum humidity
at which to apply this line.
6. On Sec: Cycle timer On time
7. Off Sec: Cycle Off time.
Enter up to 20 Cool Pad
settings. You can use the same
growth day several times, and
increase water flow for higher
temperatures.
You can flush the cool pad
daily to wash out
contaminants.
See Cool Pad Flush Settings
under Help | Set.
1.5
Control |
Foggers
Foggers options are similar to Cool
Pad except the temperature differential
is relative to Target Temperature, not
Tunnel Temp.
Restrict fogging to suitable
ventilation levels in Help | Set.
1.6
Control | Stir
Fans
The Stir Fan section provides 5
different programs. Assign programs
to individual stir fans by entering a
check mark with the +/- key.
Programs:
A. To Mix minimum ventilation air
within the house.
B. To even out temperature variations
between different ends of the
building.
C. To bring heat at the ceiling down
to floor level for the birds.
D. General Purpose program
E. General Purpose program
Set the Program Parameters
themselves under Help | Set.
The boxes at the bottom of the
screen indicate active
programs. A fan with more
than one program assigned
runs when any program
assigned is on.
1.7
Control | Light
1. Day: Growth Day
2. Start Time: Time at which lights
turn on, or sunrise starts.
3. End Time: Time at which lights
turn on, or sunset finishes.
4. For full time, set start and end
times both to 00:00.
5. Intensity: light dimmer setting.
6. To delete a line, set growth day to
0 & exit menu. Add new lines at
You can enter several start and
stop times for the same growth
day. One set of settings carries
forward until a new growth
day is programmed.
Light spiking: if using a
dimmer, program a full time
background level using 00:00
start & end times, then spike
levels at particular stop/end
times.
To Next Page
Loading...
