rotork Mk3 - Page 107

Appendix
Publication PUB089-005-00_0618 107 of 116
2 Using a National Instruments (NI) Configurator tool.
NB. - This procedure requires:
. The FF card’s software version to be at least V/M3.1B1.4H1.1.
. The FF highway to be both connected and powered up.
. The actuator’s mains power to be applied.
. The NI configurator tool to be running and have all versions of Rotork’s ITK DD files,
downloadable via:
http://www.rotork.com/en/product/index/foundationfieldbusliterature
In order to see what the current ITK version is, select the Resource Block and click on the “Others”
tab. Scroll down to the bottom of the page.
Fig F.2: Changing the ITK rev via the NI FF Configurator Tool on an IQ3 / IQT3 / SI
3
actuator
On this page, the ITK and firmware revision are shown:
- The FF card’s ITK rev (REVISION_ID) is listed as ITK6, i.e. in our card this is ITK 6.1, as only the
major revision version is shown.
- The card’s firmware rev (SW_REV) is shown as M3.1B1.4H1.1. Note that on an IQ3/IQT3
actuator’s LCD screen this will be shown as V3.1B1.4H1.