APPENDIX G – DTM
Rotork has a DTM which can be downloaded from via the following link:
http://www.rotork.com/document/index/versions/masterID/55353/
This link also contains the DTM user manual PUB089-004.
Note:
Rotork does not supply a Comm DTM nor does it supply an FDT. These must be purchased
from another vendor.
The DTM provides read / write access to the key Transducer Block parameters and can be used with
Rotork’s ITK4.6, 5.1 and 6.1 FF cards..
To Next Page
Loading...
