Rottler HP 7A - Saving and Restoring Block Profiles; Save Block Profiles to Thumbdrive; Thumbdrive Profiles to Hmi

Section 6 Maintenance HP7A Manual
www.rottlermfg.com
6-77
Saving and Restoring Block Profiles
SAVE BLOCK PROFILES TO THUMBDRIVE
First you need to exit the program so you land on the desktop. From there, you need to browse to \
residentash\hp7\. You should now see a folder called “data”. Hold your nger on the data folder and a
context menu will appear, press copy.
Now make sure a thumb drive is in the HMI. Now browse back to “My Device”. You should see a folder
called “HardDisk”; that is your thumb-drive. Double click on the HardDisk folder. Hold your nger down in
blank section of the folder, a context menu will appear, then press “paste”.
If you followed the instructions, you should have your saved proles on the thumb drive.
THUMBDRIVE PROFILES TO HMI
This process is basically the reverse of the above.
Exit the Program, you should now be in the desktop. Place the thumb drive (that has the data folder) in
the HMI. Double click “My Device”. You should see a “HardDisk” folder, that is the thumb drive. Enter
into the HardDisk folder, you should see a data folder. Hold your nger down on the data folder, a context
menu will appear, press copy.
Now go back to MyDevice. Enter into the \ResidentFlash folder. Enter into the \hp7 folder. Now, delete
the old data folder by holding your nger on the data folder, and hit delete on the context menu. Now,
that the old data folder is gone, hold your nger on a blank section of the \hp7 folder, a context menu will
appear, hit paste.
Now, a copy of the data folder from the thumb drive should be in the hp7 folder. Please note, that the les
that were previously on the machine will be deleted. Hopefully that is okay.