Section 3 Safety HP7A Manual
www.rottlermfg.com
3-5
Keep clear of spindle when working in tank area. Spindle can drop if there
is a failure in the machine. Move spindle out of work area when changing
blocks or xtures.
Remember
Machine tools have the speed and torque to severely injure any part of the human body exposed to them.
Emergency Procedure
Assuming one of the following has occurred: tool bit set completely off size, work piece or spindle base
not clamped, spindle is not properly centered, and these mistakes will become obvious the minute the cut
starts
PRESS THE EMERGENCY STOP BUTTON (on the front control panel) IMMEDIATELY!
Find out what the problem is; return the spindle to its up position without causing more damage. To
restart the machine, turn the Emergency Stop Button CW until the button pops out
Be alert to quickly stop the machine in the event of a serious disruption of the boring process either at the
top or bottom of the bores.
To Next Page
Loading...
