Section 6 Maintenance HP7A Manual
www.rottlermfg.com
6-17
Adjusting Drag Pin Tension
Disconnect all electrical and air power before making any repairs
1. Remove top rocker arm cover to gain access to drag pin adjustment.
2. Loosen set screw holding drag pin housing in place.
3. Use large screwdriver to adjust drag pin tension. It may be necessary to use a wrench on the
screwdriver to overcome hardened thread sealer.
4. When adjustment is completed tighten set screw on drag pin housing.
5. Replace top rocker arm cover.
To Next Page
Loading...
