Section 6 Maintenance HP7A Manual
www.rottlermfg.com
6-9
7. Insert one of the 1/4” ttings into the 3/8” to 1/4” adapter. Insert the 1/4” air line into the tting. Screw
the adapter into the Hydraulic Reservoir where the breather was removed.
8. Screw the other 1/4” tting into an air nozzle.
9. Slip the length of Bleeder Hose over the Bleed Valve . Run the other end of the hose into a small
container.
10. Open the bleed valve. Apply no more than 40 PSI to the 1/4” air line that runs to the top of the
Hydraulic Reservoir. As the air is applied to the reservoir, uid will come out of the Bleed Valve.
To Next Page
Loading...
