Figure 69: The Status > Wireless (Radio 2.4G/5G) > Common page
Table 53: Common Wireless settings
DescriptionSetting
Shows the wireless mode that the AP is
currently using. Possible values include:
• Auto Select: (For 802.11b/g APs only)
Allows both 802.11g- and
802.11b-compliant devices to connect
to the network. This is the default
setting.
• 2.4GHz 54 Mbps: Allows 11g devices
only.
• 2.4GHz 11 Mbps: Allows 11b devices
only.
• 11ng: Operates with 802.11n, 802.11g
and 802.11b devices in the 2.4Ghz
spectrum only.
• 11na: Operates with 802.11n and
802.11a devices in the 5GHz spectrum
only.
Wireless Mode
Shows the wireless channel that the AP is
currently using. If you set the wireless
channel to SmartSelect, this field shows
the value Channel # [SmartSelect].
Channel
11n/ac devices only. Displays whether the
channel width is set to 20, 40, or 80 MHz.
Channel Width
Shows the country code that the AP has
been set to use.
CAUTION! Verify that the AP is using the
correct country code to make sure it uses
only the allowed radio channels in your
region. Selecting the incorrect country code
may result in violation of applicable laws.
Country Code
Shows Enabled if you enabled AeroScout
RFID tag detection. The default setting is
Disabled.
AeroScout RFID tag detection (some APs)
ZoneFlex Indoor Access Point Release 104.0 User Guide
131
Administration
Viewing Common Wireless Settings
To Next Page
Loading...
