Figure 71: The Configuration > Device page
3. Under Service Provider Login, change the default administrator login settings.
• In Username, type a new user name to log in to the web interface. The default
user name is super.
• In Current Password, enter the existing password.
• In New Password, type a new password to replace the default password
sp-admin. The password must consist of six to 32 alphanumeric characters only.
• In Confirm New Password, retype the new password.
4. Click Update Settings. The message Your parameters were saved appears. You
have completed changing the default login settings. The next time you log in to the
web interface, make sure you use these updated login settings.
Enabling Other Management Access Options
Use the Administration > Management page to configure AP management options.
In addition to managing the AP via a web browser through HTTPS, several other
management access options are available on the AP. These options include management
access via HTTP, Telnet, and SSH.
You can also view and set up the connection to a Ruckus Wireless FlexMaster server
under the TR-069/SNMP Management Choice options. If your Ruckus Wireless device
is to be managed by FlexMaster, then the FlexMaster information (server URL and contact
interval) is preconfigured before you receive your Ruckus wireless device.
NOTE If you are configuring the AP to be managed by FlexMaster, remember to point
it to the FlexMaster server after you configure the management access options. For more
information, refer to Viewing FlexMaster Management Status on page 138.
1. Go to Administration > Management. The Management page appears.
134
ZoneFlex Indoor Access Point Release 104.0 User Guide
Administration
Enabling Other Management Access Options
To Next Page
Loading...
