DescriptionSetting
Shows Up if the communication agent on
the AP is able to relay location data from
AeroScout Tags to the AeroScout Engine.
If the communication agent is unable to
relay data or AeroScout tag detection is
disabled, this field shows Down.
AeroScout Engine communication daemon
(some APs)
Shows Enabled if you have enabled Ekahau
RFID tag detection. Default is disabled.
Ekahau Engine communication daemon
(some APs)
Ekahau Real Time Location System RTLS
Controller IP address.
ERC IP (some APs)
TCP port used by the Ekahau Real Time
Location System RTLS Controller.
ERC Port (some APs)
If you want to make changes to any of these settings, go to the Configuration > Wireless
page. Refer to Configuring Common Wireless Settings on page 99 for more information.
Viewing Associated Wireless Clients
The Status > Wireless page provides an overview of currently connected wireless clients.
A usage-monitoring capability has been built into the AP to help you monitor wireless
clients that are associated with your wireless network.
1. Go to Status > Wireless. The Status > Wireless page appears.
NOTE If you are using a dual-band AP, then go to Status > Radio 2.4G or Status
> Radio 5G.
2. Click any of the Wireless # tabs. Wireless clients that are associated with this
particular wireless network appear under Connected Devices.
132
ZoneFlex Indoor Access Point Release 104.0 User Guide
Administration
Viewing Associated Wireless Clients
To Next Page
Loading...
