ZoneFlex 7055 Wall Switch
The ZoneFlex 7055 is a multiservice 802.11n dual-band concurrent two-stream
wired/wireless wall switch.
NOTE The 100.x AP base images support standalone mode and FlexMaster (FM)
WLAN manager operation. The SmartZone software-compatible images only support
Ruckus Wireless SCG, SZ and vSZ controllers. The ZD-compatible images only support
ZD controllers.
NOTE The 7055 requires a minimum of AP base image 100.0.0 and later to operate,
or SCG 1.0 and later, vSZ 2.5 and later, SmartZone software 3.2 and later, or ZD 9.6
and later to operate.
The 7055 is designed for installation in an electrical junction box. This section identifies
the physical features the 7055. Before you begin the installation process, Ruckus Wireless
recommends that you become familiar with these features.
Front View Features
The front view of the 7055 includes four Ethernet Ports, a pass through port and a DC
in socket on the bottom front panel. Refer to the following table for more information.
ZoneFlex Indoor Access Point Release 104.0 User Guide
9
Introduction
Getting to Know the AP Features
To Next Page
Loading...
