• DNS entry named "ruckuscontroller.<local domain>"
• AP CLI command "set scg ip"
ZoneDirector
APs discover ZoneDirector controllers using any of the following methods:
• IP subnet broadcast
• DHCP Option 43 sub-option 3
• DHCPv6 Option 17 sub-option 3
• DHCPv6 Option 52
• DNS entry named "zonedirector.<local domain>"
• AP CLI command "set director ip"
Getting to Know the AP Features
This section identifies the physical features of each Ruckus Wireless AP model that is
discussed in this guide. Before you begin the installation process, Ruckus Wireless
recommends that you become familiar with these features.
NOTE This User Guide does not include information on Ruckus Wireless Outdoor APs
or the ZoneFlex 7731 or P300 Wireless Bridge products. For information on those
ZoneFlex AP models, along with Ruckus Wireless ZoneDirector and SmartZone
controllers, FlexMaster, and other product lines, refer to their respective user
documentation available from support.ruckuswireless.com.
This release supports the following ZoneFlex indoor AP models:
• ZoneFlex 7055 Wall Switch on page 9
• ZoneFlex 7352 on page 17
• ZoneFlex 7372 on page 21
• ZoneFlex 7372-E on page 25
• ZoneFlex 7982 on page 28
• ZoneFlex H500 Wall Switch on page 32
• ZoneFlex H510 Wall Switch on page 38
• ZoneFlex R300 on page 42
• ZoneFlex R310 on page 45
• ZoneFlex R500 on page 49
• ZoneFlex R510 on page 53
• ZoneFlex R600 on page 57
• ZoneFlex R700 on page 61
• ZoneFlex R710 on page 65
8
ZoneFlex Indoor Access Point Release 104.0 User Guide
Introduction
Getting to Know the AP Features
To Next Page
Loading...
