3. Click Perform Upgrade. A status bar appears during the upgrade process.
4. After the upgrade is completed, you must manually reboot the AP.
Upgrading Manually via the Web
Use the following procedure to upgrade the AP manually via the web.
1. In the Upgrade Method options, click Web.
2. If instructed to choose a different URL than the default value, click the Web Options
URL field, and then type the URL of the download website. Remember to start the
URL with "http://".
3. Click Perform Upgrade. A status bar appears during the upgrade process.
4. After the upgrade is completed, you must manually reboot the AP.
Upgrading Manually via Local File
If you have already saved an image file on your local computer, then you can upgrade
directly using the web interface.
1. In the Upgrade Method options, choose Local.
2. Click the Choose File button and locate the file on your local computer.
3. Select the file and click OK.
4. Click Perform Upgrade. A status bar appears during the upgrade process.
5. After the upgrade is completed, the AP must be rebooted.
Scheduling Automatic Upgrades
Use the following procedure to schedule automatic upgrades.
1. In the Upgrade Method options, click the button for your preferred choice.
2. Enter the required information in the related fields.
CAUTION! Do not change any of the Image Control File, Username or Password
entries.
3. Set the Auto Upgrade option to Enabled.
4. Toggle the Interval to Check for Software Upgrade drop-down list to select your
preferred interval.
5. Choose whether to reboot immediately after upgrading, or schedule the reboot for
a specific time of day using the Schedule Reboot Time After Upgrade list. Choosing
Any Time (the default value) results in the AP performing a reboot immediately after
the automatic upgrade is successful.
6. You have two options at this point:
ZoneFlex Indoor Access Point Release 104.0 User Guide
143
Administration
Upgrading the Firmware Image
To Next Page
Loading...
