Rugged Radios RM-50 - CW Identifier Setup

48 49
N
OTE
A
UTO
R
ANGE
T
RANSPONDER
S
YSTEM
(ARTS)
CW Identier Setup
The ARTS feature includes a CW identier, as discussed previously. Every ten minutes
during ARTS operation, the radio can be instructed to send “DE (your callsign) K” if this
feature is enabled. The callsign eld may contain up to 6 characters.
Here’s how to program the CW Identier:
1. Press and hold in the [
BAND
(
SET
)] key for 1/2 second to enter the Set mode.
2. Rotate the
DIAL
knob to select Menu #8 (
CW
WRT
).
3. Press the [
BAND
(
SET
)] key momentarily.
4. Press the [
BAND
(
SET
)] key momentarily again to
enable entry of your callsign.
5. Rotate the
DIAL
knob one click clockwise to begin
entry of the letters and numbers in your callsign.
6. Press the [
BAND
(
SET
)] key momentarily to set the
rst letter or number in your callsign.
7. When the correct character has been selected, press
the [
BAND
(
SET
)] key momentarily to move on to
the next character.
8. Repeat steps 6 and 7 as many times as necessary to
complete your callsign.
9. Press the [
SCAN
(
SEL
)] key to delete all data after
the cursor that may have been previously stored (erroneously).
10. When you have entered your entire callsign, press and hold in the [
BAND
(
SET
)] key
for 1/2 second to conrm the callsign, then press and hold in the [
BAND
(
SET
)] key
for 1/2 second to exit to normal operation.
11. Press and hold in the [
BAND
(
SET
)] key for 1/2 sec-
ond to enter the Set mode again, then rotate the
DIAL
knob to select Menu #7 (
CWID
).
12. Press the [
BAND
(
SET
)] key momentarily, then rotate
the
DIAL
knob to select “
TX ON
” (to enable the CW
identier).
13. Press the [
BAND
(
SET
)] key momentarily to save the new setting, then press and hold
in the [
BAND
(
SET
)] key for 1/2 second to exit to normal operation.