Installation - TT-3020C
Installation - TT-3020CInstallation - TT-3020C
Installation - TT-3020C Power requirements
Power requirementsPower requirements
Power requirements
Page
PagePage
Page 2-4
2-42-4
2-4 25-Jul-00
25-Jul-0025-Jul-00
25-Jul-00
2.3 Power requirements
The TT-3020C Maritime Capsat transceiver is designed to operate
on floating DC in the range 10 - 32 V, which makes an AC/DC
converter needed, in case the system is to work in an AC envi-
ronment.
The total power consumption varies with the particular system in
question. As a guide-line, please note the power consumption of
the following equipment:
Power requirements Receive
mode
Transmit
mode
TT-3020C Capsat Transceiver incl. TT-3005M
Antenna.
Floating DC (10-32V).
3.8W 80W
Max.
90W
TT-3020C Capsat Transceiver incl. TT-3005M
Antenna & GPS.
Floating DC (10-32V).
4..4W 80W
Max.
90W
Table 3 TT-3020C power requirements
2.3.1 Fuse
The TT-3020C has a single fuse, which can be found on the rear
panel. In case it needs replacement a 12 A T type must be used.
2.4 Functional description
This section describes the functions of the TT-3020C Maritime
Capsat transceiver.
2.4.1 On/Off features
The TT-3020C Transceiver/GPS is powered from a DC source (10-
32V). The system is switched ON by the ON/OFF switch S1 placed
Document Nr: I-MA-3010.68-5510-762-IVT-312
To Next Page
