Sailor H2095C - TT-3601 E Keyboard

TT-3606E Message Terminal
TT-3606E Message TerminalTT-3606E Message Terminal
TT-3606E Message Terminal System Installation
System InstallationSystem Installation
System Installation
25-Jul-00
25-Jul-0025-Jul-00
25-Jul-00 Page
PagePage
Page 3-25
3-253-25
3-25
The CTS and DTR hardware handshake signals are used as de-
fault.
The pin assignment for the two communication ports are identi-
cal.
3.4.1.3 Printer port
The TT-3606E Message Terminal has a standard Centronics
printer port. Please note that in the GMDSS system the TT-3608A
Hard Copy printer must be connected to the Transceiver.
The printer port connector is located on the rear panel.
3.4.2 TT-3601E keyboard
The TT-3601E Keyboard plugs into the Keyboard connector on
the rear panel of the TT-3606E. The keyboard connector is a stan-
dard connector but please be aware that only the TT-3601E key-
board is approved for GMDSS purposes.
Power: The keyboard is powered from TT-3606E Message
Terminal.
Grounding: TT-3601E Keyboard does normally not require any
separate grounding.
Document Nr: I-MA-3010.68-5510-762-IVT-312
Page 447 of 1234