EasyManua.ls Logo

Sailor H2095C - Page 22

Sailor H2095C
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety Summary
Safety SummarySafety Summary
Safety Summary
The following general safety precautions must be observed during all phases of
operation, service and repair of this equipment. Failure to comply with these
precautions or with specific warnings elsewhere in this manual violates safety
standards of design, manufacture and intended use of the equipment.
Thrane & Thrane A/S assumes no liability for the customers failure to comply with
these requirements.
GROUND THE EQUIPMENT
GROUND THE EQUIPMENTGROUND THE EQUIPMENT
GROUND THE EQUIPMENT
To minimise shock hazard, the equipment chassis and cabinet must be connected to
an electrical ground
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHEREDO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the equipment in the presence of flammable gases or fumes. Opera-
tion of any electrical equipment in such an environment constitutes a definite safety
hazard.
KEEP AWAY FROM LIVE CIRCUITS
KEEP AWAY FROM LIVE CIRCUITSKEEP AWAY FROM LIVE CIRCUITS
KEEP AWAY FROM LIVE CIRCUITS
Operating personnel must not remove equipment covers. Component replacement
and internal adjustment must be made by qualified maintenance personnel. Do not
replace components with the power cable connected. Under certain conditions,
dangerous voltages may exist even with the power cable removed. To avoid injuries,
always disconnect power and discharge circuits before touching them.
DO NOT SERVICE OR ADJUST ALONE
DO NOT SERVICE OR ADJUST ALONEDO NOT SERVICE OR ADJUST ALONE
DO NOT SERVICE OR ADJUST ALONE
Do not attempt internal service or adjustments unless another person, capable of
rendering first aid resuscitation, is present.
DO NOT SUBSTITUTE PARTS OR MODIFY EQUIPMENT
DO NOT SUBSTITUTE PARTS OR MODIFY EQUIPMENTDO NOT SUBSTITUTE PARTS OR MODIFY EQUIPMENT
DO NOT SUBSTITUTE PARTS OR MODIFY EQUIPMENT
Because of the danger of introducing additional hazards, do not substitute parts or
perform any unauthorized modification to the equipment.
SAFETY DISTANCE FOR THE ANTENNA UNIT
SAFETY DISTANCE FOR THE ANTENNA UNITSAFETY DISTANCE FOR THE ANTENNA UNIT
SAFETY DISTANCE FOR THE ANTENNA UNIT
Minimum safety distance of 2 feet (61 cm) from the Antenna.
Radiated intensity at 0.56m is 10 W/m
2
Radiated intensity at 0.36m is 25 W/m
2
Radiated intensity at 0.18m is 100 W/m
2
COMPASS SAF
COMPASS SAFCOMPASS SAF
COMPASS SAFE DISTANCE
E DISTANCEE DISTANCE
E DISTANCE
Minimum safety distance of 50 cm from the TT-3020C transceiver
Document Nr: I-MA-3010.68-5510-762-IVT-312
Page 391 of 1234

Table of Contents

Related product manuals