System Installation
System InstallationSystem Installation
System Installation TT-3608G Printer Unit
TT-3608G Printer UnitTT-3608G Printer Unit
TT-3608G Printer Unit
Page
PagePage
Page 3-40
3-403-40
3-40 25-Jul-00
25-Jul-0025-Jul-00
25-Jul-00
• The Arcnet bus will have two ends and both of these should be
terminated with a 100 Ohm resistor (± 1%). The TT-3608G
does NOT contain any termination-resistor. If needed the ter-
mination resistor could be placed in the 15 pole SubD con-
nector connected to the twisted pair cable. This is the case for
the accompanying cable.
• Always use shielded twisted pair cables and shielded con-
nectors (otherwise the EMC specifications are not guarantied
to be fulfilled).
• The length of the cable making up the Arcnet bus should be
no longer than 100 meters.
• Minimum spacing between devices connected to the Arcnet
bus is 2 meter of cable.
• No more than 8 Arcnet devices (including transceiver) must
be connected to the Arcnet bus.
Document Nr: I-MA-3010.68-5510-762-IVT-312
To Next Page
Loading...
