Sam4s ER-285M - Program 300 - PLU Description Programming

134 • Program Mode Reference Guide SAM4s ER-285M Operator's and Program Manual v1.4
Program 300 - PLU Description Programming
Program descriptors by typing descriptors on the alpha keyboard overlay or by
entering three-digit alpha character codes. Go to system option #32 to choose the
method you wish to use. The descriptor code method is the default method.
1. Turn the control lock to the PGM position
2. To begin the program, enter 3 0 0, press the SUBTOTAL key.
0
SUB
TOTAL
0 3
3. Select the PLU you wish to program in one of the following ways:
• Press a PLU key on the keyboard, or
PLU
• Enter up to 15 digit number of the PLU and press the PLU key, or
PLU
Enter the PLU#,
up to 15 digits
4. If you are programming using alpha overlay;
X/TIME
Type up to 18
descriptor keys
or,
Enter up to 18
three-character
codes
X/TIME
5. To program additional PLUs, repeat from step 3, or press the CASH key to
finalize the program.
CASH