Sam4s ER-285M - Program 400 - PLU Delete Programming

136 • Program Mode Reference Guide SAM4s ER-285M Operator's and Program Manual v1.4
Program 400 – PLU Delete Programming
NOTE: To delete a PLU, all totals for the PLU must be cleared from Z reports
(including Stock and PLU reports.)
1. Turn the control lock to the PGM position.
2. To begin the program, enter 4 0 0, press the SUBTOTAL key.
0
SUB
TOTAL
0 4
3. Select the PLU or PLUs you wish to program in one of the following ways:
• Press a PLU key on the keyboard, or
PLU
• Press the first PLU to be deleted and then press the last PLU key to be
deleted, or
PLU PLU
• Enter up to 15 digit number of the PLU and press the PLU key, or
PLU
Enter the PLU#,
up to 15 digits
• Enter the number of the first PLU in a range you wish to delete and press
the PLU key. Enter the last number in the range; press the PLU key.
PLU
Enter the PLU#,
up to 15 digits
Enter the PLU#,
up to 15 digits
PLU
4. Press X/TIME key.
X/TIME
5. To delete additional PLUs, repeat from step 3, or press the CASH key to
finalize the program.
CASH