Sam4s ER-285M - Date and Time Programming

SAM4s ER-285M Operator's and Program Manual v1.4 Program Mode Reference Guide • 193
Date and Time Programming
Use this program to set the clock and calendar on your ER-285M Series. The date changes
automatically. After initial setting, time changing will probably be required only for
beginning and ending daylight savings time.
Programming the Date and Time
1. Turn the control lock to the PGM position.
2. To begin the program, enter 1 3 0 0, press the SUBTOTAL key.
0
SUB
TOTAL
0 3 1
3. Enter time in military standard time (based on 24 hours), must be four digits
(i.e. 1300 hours = 1:00 PM); press the X/TIME key.
H H X/TIMEM M
4. Enter the date in MM (month) DD (day) and YY (year) format. Press the
X/TIME key:
M M D D X/TIMEY Y
6. Press the CASH key to finalize the program.
CASH