Sam4s ER-285M - Function Key Programming

SAM4s ER-285M Operator's and Program Manual v1.4 Program Mode Reference Guide • 147
Function Key Programming
Three programs are used to program function keys:
• Program 70 - is used to set each keys individual options
• Program 80 - is used to program a 18 character alpha numeric descriptor
• Program 90 - is used to set a high amount limit (HALO)
In this chapter you will find:
• General instructions for programs 80 and 90.
• Individual Program 70 option programming for each function key (options vary
by function)