Sam4s ER-285M - Saving Reports to an SD Card; Firmware Update by SD Card

198 • Program Mode Reference Guide SAM4s ER-285M Operator's and Program Manual v1.4
Backing Up the Program to an SD Card
CAUTION: When backing up and restoring data, the store name must be programmed
in system option #30.
1. Turn the control lock to the S position.
2. To backup the program to SD, enter 1 0 0, press the SUBTOTAL key.
0
SUB
TOTAL
0 1
Restore Program from the SD Card
CAUTION: Memory allocation must be set the same as the saved program. Be sure to
print out the memory allocation so that it can be re-enterd before restoring the
program.
1. Turn the control lock to the S position.
2. To load the program to the register from the SD card, enter 1 1 0, press the
SUBTOTAL key.
0
SUB
TOTAL
1 1
Saving Reports to an SD Card
Reports saved are the current X1 readings.
1. Turn the control lock to the S position.
2. To backup Reports to SD, enter 1 0 1, press the SUBTOTAL key.
1
SUB
TOTAL
0 1
Firmware Update by SD Card
You can use a SD flash memory card to update the register firmware. (When necessary,
update files are supplied by CRS in the form of a file named “ER-280.BIN” and posted on the
dealer pages of www.crs-usa.com. Detailed update instructions will be supplied with the
update package.)
To perform an update:
1. At your PC, create a folder in the root of the SD card named “update”.
2. Copy the update file “ER-280.BIN” to the “update” folder.
3. Place the SD card in the SD port of the ER-285M, located on the right side of the
register.
4. Turn the key lock to the S position. (Note that the S position is one position clock-
wise from the PGM position. The S position is not labeled.)
5. Enter 55, press SUBTOTAL, and then press CASH. The display will indicate that
the card is being read. The register will beep three times when the update is
complete.
6. RAM Clear the register. See “Quick Start Step #3: Memory All Clear” on page 21.